FB info: https://www.facebook.com/media/set/?vanity=printalure&set=a.1073205352829027

NOTE: tails have deep air vents and through holes to avoid air pockets so:
a) be careful, point tail vents away from you and don't push hard (plastic will flow out)
b) be prepared to remove plastic bits that enter air vents.

Almost everything on this site is made to order (hence a "pre-order" status on most products). 

Please read this info carefully and only order if you're okay with everything:

If you have questions or need some assistance, please contact us via messaging on our FB page: 

https://www.facebook.com/printalure