Deep ribbed "ridged" beaver tail 

NOTE: this specific design needs some deep vents in order to be poured fully and consistently so:

1) You'll have to remove plastic pieces after pouring;
2) DON'T PUSH HARD AND POINT THE MOLD' SIDES WITH DEEP VENTS AWAY FROM YOU! The plastic will flow our from these vents. BE EXTRA CAREFUL!

Don't buy this mold if said above is gonna be an issue for you!

Pictured is before and after trimming:



Almost everything on this site is made to order (hence a "pre-order" status on most products). 

Please read this info carefully and only order if you're okay with everything:

If you have questions or need some assistance, please contact us via messaging on our FB page: 

https://www.facebook.com/printalure